Improved Rumble Strip Cutter Boasts Tier 4 Interim Emissions Controls

Wirtgen America’s new high-performance rumble strip cutter – the W 50 DCi Rumbler – was introduced at Conexpo-Con/Agg 2014.

The W 50 DCi Rumbler is a standard W 50 DCi cold milling machine with an optional Rumbler attachment installed, providing high-production, high-profitability cutting of milled rumble strips in the standard, preferred 16-in. width at speeds of up to 180 fpm. The W 50 DCi driving unit is Tier 4 Interim-compliant.

Without the Rumbler installed, the deep-cutting W 50 DCi cuts 8 in. deep and a variety of widths up to 20 in. Its 127 hp diesel engine, combined with a more robust 17,000-lb. design, 10-in. turning radius and standard rear loading conveyor, makes this a premier performer in the utility class.

Addition of the Wirtgen Rumble Strip Milling attachment makes the W 50 DCi even more valuable to an owner. Together they result in a durable, reliable cold mill for general milling use, combined with a proven milling technology for cutting milled rumble strips in shoulders, or down centerlines of two-way pavements.

The W 50 DCi Rumbler features a six-sided rumble wheel with urethane pads, powered by a hydraulic rumble wheel drive. The Rumbler drum and wheel can be mounted on either the left- or right-hand side of the W 50 DCi, with easy cutter access.

The W 50 DCi Rumbler cutter drive is an extension of the W 50 DCi’s standard drum drive system, using a mechanical belt drive, which has proven more efficient and reliable than hydraulic drive. The heavy construction of the Rumbler frame assures long life.

A simple wheel/pad assembly rolls along the pavement surface to actuate the Rumbler sub-frame in and out of the cut. Custom drum widths and pad sets are available. Special patterns can be achieved with special rumble wheel pads. Intermittent patterns can be achieved with the available Skip Line Kit. For optimal cutting, W1-10/S-R Rhino bits can be used.

A standard, long front pointer is designed for stable, accurate correction when on the job, essential for tracking intermittent references like the pavement “drip” line or a centerline. A short pointer also is installed as a standard. Both provide a dual reference which can give the operator a better sense of the W 50 DCi’s Rumbler’s position.

The Federal Highway Administration’s Technical Advisory (T 5040.35) endorses shoulder rumble strips for driver safety from run-off-road events, and maintains that milled-in strips are the best option. FHWA says milled rumble strips are superior because they have little or no effect on the integrity of the pavement structure, and produce greater noise and vibration than rolled or formed rumble strips

While rumble strips can be rolled-in for freshly placed asphalt shoulders, research by the Pennsylvania Turnpike Commission found strips milled into existing shoulders to be superior to rolled-in rumble strips.

_______________________________________________________

For further information, please contact:

Wirtgen America, Inc.
Ken Snover
6030 Dana Way
Antioch, TN 37013

Phone: 615-501-0600
Fax: 615-501-0691
email: Ken.Snover@wirtgen-group.com

BACKGROUNDER

WIRTGEN AMERICA Inc., Nashville, is the North American headquarters of the WIRTGEN GROUP, the single-source marketer of the world's most technologically advanced lines of asphalt reclaiming/recycling, concrete slipform, and surface mining equipment from WIRTGEN, asphalt and soil compactors from HAMM, asphalt pavers from VÖGELE, and construction materials processing equipment from KLEEMANN.

Reinhard Wirtgen, founder of WIRTGEN GROUP, was honored as one of the "Top 100 Private Sector Transportation Design & Construction Professionals of the 20th Century" by the American Road & Transportation Builders Association (ARTBA).

Back to overview

EN-US